The Norden Bomb Sight manual

Accept-

ance of

Sight,

Stabil-

izer ard

Calibrat-

ion Units.

C.L.1.

C-42-3

bottom screw of the top bus bar on the left hand

sidebar directly

secure it to the top terminal of the

bus

below.

4. Cautions.

If bus bars are separated by fibre

be sure separators are

replaced to

avoid

circuit.

E: Replace cover:

Never roll or fold this cover.

d.

Prominately

mark cover, or attach-

meni Plug, "24 Volts.

it is

sometimes necessary for a maintenance

man to assume responsibility for the acceptance of

units in the

field.

In accepting sight units or

other BSM equipment, a set procedure

is followed,

and

this part of the

supplement might be called an

inventory check of Acceptance.

It is seldom

that a maintenance man is called upon to

assume

this responsibility, but since it is true in

iso-

lated cases we present this material for his bene-

fit.

&.

Inventory List of Bombsight Assembly Consists

Of:

I Bombsight

Directional Stabilizer

Bombsight cover.

Log book and cover (sometimes sent separate).

I L.A. Device and bracket.

2 Precession 9"

arts (in

log books).

I Kit of Scales (12)

I Hand held disk speed tachometer No.

/ Envelope conta

ning release lever locking ar-

rangement.

I envelope

contrining B.S. coupling collar,

locking pin and shims (when Bombsight unit only

is sent.)

The !

ntory

List Of The Bombsight Calibrat-

ion Outt

Should Consist of The Following:

al,

three point adjustment, including:

inst: ument Panel

Adapter for M-4 sight.

Revolving head

Pilot director indicator

Ammeter

Voltmeter

I Beam

Target Tape, including:

bar

a.

separators,

short

c.

Replace

cover.

b.